ELECRAFT KRX3 Instruções de Operação descarregar pdf (Página 28)

Figure 32. Removing Side Panel Hardware, Part 2.

Remove the dummy plug from the AUX RF connector hole in the back panel directly below the SO-239

ANT2 connector. The plug is released by squeezing two tabs on opposite sides.

Check the BNC-TMP cable assembly to see if the nut and lock washer are already threaded onto the BNC

connector. If so, remove them completely, working carefully to slide them over the ground braid and lug. (Lay

the lug attached to the ground braid along the cable to slide the parts over it.)

The dense, highly scratch-resistant powder coating on the rear panel may interfere with the fit of the BNC

connector through the hole. Remove the coating around the inside edge of hole using a hobby knife or other

sharp tool (see Figure 33).

Figure 33. Installing AUX RF Connector, Part 1.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 51 52

Sem comentários

ELECRAFT KRX3 Instruções de Operação Página 28