Elecraft KX3 Programmers Reference Manual do Utilizador descarregar pdf (Página 25)

Appendix A: Change History [Applicable MCU revisions shown in brackets]

Note: Prior to revision D1 this document applied only to the K3. For earlier change history, see rev C14.

D1, 1-18-2012 [K3, rev 4.48; KX3, rev 0.58]

! Document now pertains to both the K3 and KX3. Asterisks in Table 1 now show K3 commands that are not

functionally applicable to the KX3. (For K2 commands, refer to the KIO2 Programmer’s Reference.)

! SWT/SWH, MN, and OM descriptions updated to show differences between K3 and KX3.

D2, 1-19-2012 [K3, rev 4.48; KX3, rev 0.59]

! KXAT3 menu entry back to MN023.

! XMIT/TUNE switch on KX3 remapped to match the K3’s SWT/SWH code (13). This allows KX3

Utility’s TX GAIN cal function work without being rewritten.

D5, 3-20-2012 [K3, rev 4.48; KX3, rev 0.80]

! DB command is different for the KX3.

! RG response is different for the KX3.

! MQ command added for the KX3 (16-bit menu parameter access)

! SPG command added (KX3 ground-reference check).

! SMH command added (K3 high-resolution S-meter; to be added to the KX3 later)

D8, 4-5-2012 [K3, rev 4.48; KX3, rev 0.91]

! PO command added (reads actual power output during transmit).

! EL command added (turns run-time error logging on/off). Error logging, when ON, reports “ERR xxx” and

other events to the attached PC, unsolicited.

D9, 4-12-2012 [K3, rev 4.48; KX3, rev 0.92]

! Added RX SHFT menu entry to KX3’s MN command ID list.

D10, 4-17-2012 [K3, rev 4.48; KX3, rev 0.92]

! Corrected NL command description, including note about the KX3 noise blanker, which does not yet use

the NL command.

E2, 5-7-2012 [K3, rev 4.50; KX3, rev 0.99]

! [KX3] The MN command table now reflects all of the KX3 menu parameters accessible via MP and MQ.

! [KX3] The MP command now has a full list of menu entries for which the MP get/set parameters reference

only a subset of the 8 bits. Semantics and examples for these parameters are provided.

E3, 7-12-2012 [K3, rev 4.51; KX3, rev 1.10]

! [KX3] Added RX NR to MN table.

E4, 9-18-2012 [K3, rev 4.51; KX3, rev 1.20]

! [KX3] Added internal-only commands BC and KT to command table (documented elsewhere).

1 2 ... 20 21 22 23 24 25 26

Sem comentários

Elecraft KX3 Programmers Reference Manual do Utilizador Página 25